Formatting an SD card/Linux: Difference between revisions

Formatting an SD card/Linux (view source)

Revision as of 22:46, 11 June 2022

123 bytes removed , 2 years ago

no edit summary

Abuse filter editor, Bureaucrats, Check users, Interface administrators, Staff, Suppressors, Administrators, Translation Reviewer

2,193

edits

@@ Line 1: / Line 1: @@
-{% include toc title=“Table of Contents” %}
-<span id="required-reading"></span>
-=== Required Reading ===
 This is an add-on section for formatting an SD card to work with the 3DS.
 If the 3DS already recognizes the SD card, this guide is not required.
-This page is for Linux users only. If you are not on Linux, check out the [[formatting-sd-(windows)|Formatting SD (Windows)]] or [[formatting-sd-(mac)|Formatting SD (Mac)]] pages.
+This page is for Linux users only. If you are not on Linux, check out the [[Special:MyLanguage/Formatting an SD card/Windows|Windows]] or [[Special:MyLanguage/Formatting an SD card/Mac|Mac]] pages.
-<span id="instructions"></span>
+== Instructions ==
-=== Instructions ===
 # Make sure your SD card is '''not''' inserted
 # Launch the Linux Terminal
-# Type <code>watch &quot;lsblk&quot;</code>
+# Type <code>watch "lsblk"</code>
 # Insert your SD card into your PC
-# Observe the output. It should match something like this:
+# Observe the output. It should match something like this: {{#tag:syntaxhighlight|
+NAME        MAJ:MIN RM   SIZE RO TYPE MOUNTPOINT
-<pre>NAME        MAJ:MIN RM   SIZE RO TYPE MOUNTPOINT
 mmcblk0     179:0    0   3,8G  0 disk
-└─mmcblk0p1 179:1    0   3,7G  0 part /run/media/user/FFFF-FFFF</pre>
+└─mmcblk0p1 179:1    0   3,7G  0 part /run/media/user/FFFF-FFFF
+}}
 # Take note of the device name. In our example above, it was <code>mmcblk0p1</code>
+#* If <code>RO</code> is set to 1, make sure the lock switch is not slid down
-* If <code>RO</code> is set to 1, make sure the lock switch is not slid down
 # Hit CTRL + C to exit the menu
 # Type in the following for your SD card: