Toggle menu
Toggle personal menu
Not logged in
Your IP address will be publicly visible if you make any edits.

Formatting an SD card/Windows: Difference between revisions

From Hacks Guide Wiki
(Cleared confusion on 65536 cluster size reverting to 32768 for GUIFormat)
(Cleared confusion on 65536 cluster size reverting to 32768 for GUIFormat)
 
(No difference)

Latest revision as of 20:46, 19 June 2024

Other languages:
  • English

This is an add-on section for formatting an SD card to FAT32.

This page is for Windows users only. If you are not on Windows, check out the Linux or Mac pages.

Choose your SD card size

What You Need

Instructions

  1. Insert your SD card into your computer
  2. If the SD card has any files and folders on it, copy everything to a folder on your computer
  3. Run SD Card Formatter Setup (the .exe file) in the downloaded .zip file with Administrator privileges, then install the program
  4. Run SD Card Formatter from the Start Menu
  5. Select your SD card’s drive letter for "Select card"
      Make sure you choose the correct drive letter, otherwise you might accidentally erase the wrong drive!
  6. Ensure that "Quick Format" is selected
  7. Click "Format"
  8. Click "OK"
  9. Wait for the format to finish
  10. Click "OK"
  11.   You're not done yet! Your SD card will be formatted to exFAT at this point. The following steps will format it to FAT32.
  12. Close SD Card Formatter
  13. Run guiformat.exe
  14. Select your SD card’s drive letter for "Drive"
      Make sure you choose the correct drive letter, otherwise you might accidentally erase the wrong drive!
  15. Select a size for "Allocation unit size"
    • If the SD card is 64GB, choose 32768
    • If the SD card is larger than 64GB, choose 65536 (note that if GUIFormat reverts to 32768, this does not mean it selected the wrong cluster size!)
  16. Ensure that "Quick Format" is selected
  17. Click "Start"
  18. Click "OK"
  19. Wait for the format to finish
  20. Click "Close"
  21. If the SD card had any files and folders on it before the format, copy everything back from your computer

Common errors with guiformat

Failed to open device: GetLastError()=32

Close everything that may be using the SD card, such as any File Explorer windows. If it does not resolve the issue, try formatting the card to NTFS, then run GUIFormat again.

GetLastError()=1117

Your SD card write-protection switch may be enabled. The lock must be flipped upwards to allow writing to the SD card (including formatting).

What You Need

Instructions

  1. Insert your SD card into your computer
  2. If the SD card has any files and folders on it, copy everything to a folder on your computer
  3. Run SD Card Formatter Setup (the .exe file) in the downloaded .zip file with Administrator privileges, then install the program
  4. Run SD Card Formatter from the Start Menu
  5. Select your SD card’s drive letter for "Select card"
      Make sure you choose the correct drive letter, otherwise you might accidentally erase the wrong drive!
  6. Ensure that "Quick Format" is selected
  7. Click "Format"
  8. Click "OK"
  9. Wait for the format to finish
  10. Click "OK"
  11. Close SD Card Formatter
  12. If the SD card had any files and folders on it before the format, copy everything back from your computer

SD Card not formatting or has some other issue.

Refer to the SD Clean guide.