Formatting an SD card/Windows

This is an add-on section for formatting an SD card to FAT32.

This page is for Windows users only. If you are not on Windows, check out the Linux or Mac pages.

Choose your SD card size

64GB or larger32GB or smaller

What You Need

• The latest version of SD Memory Card Formatter
• The latest version of guiformat

Instructions

1. Insert your SD card into your computer
2. If the SD card has any files and folders on it, copy everything to a folder on your computer
3. Run SD Card Formatter Setup (the .exe file) in the downloaded .zip file with Administrator privileges, then install the program
4. Run SD Card Formatter from the Start Menu
5. Select your SD card’s drive letter for "Select card"

   Make sure you choose the correct drive letter, otherwise you might accidentally erase the wrong drive!

6. Ensure that "Quick Format" is selected
7. Click "Format"
8. Click "OK"
9. Wait for the format to finish
10. Click "OK"

You're not done yet! Your SD card will be formatted to exFAT at this point. The following steps will format it to FAT32.

11. Close SD Card Formatter
12. Run guiformat.exe
13. Select your SD card’s drive letter for "Drive"

    Make sure you choose the correct drive letter, otherwise you might accidentally erase the wrong drive!

14. Select a size for "Allocation unit size"
    • If the SD card is 64GB, choose 32768
    • If the SD card is larger than 64GB, choose 65536
15. Ensure that "Quick Format" is selected
16. Click "Start"
17. Click "OK"
18. Wait for the format to finish
19. Click "Close"
20. If the SD card had any files and folders on it before the format, copy everything back from your computer
    • If you are in the process of following the MSET9 fresh troubleshooting guide, skip this step, or else the error is likely to keep happening.

Common errors with guiformat

Failed to open device: GetLastError()=32

Close everything that may be using the SD card, such as any File Explorer windows. If it does not resolve the issue, try formatting the card to NTFS, then run GUIFormat again.

GetLastError()=1117

Your SD card write-protection switch may be enabled. The lock must be flipped upwards to allow writing to the SD card (including formatting).

What You Need

• The latest version of SD Memory Card Formatter

Instructions

1. Insert your SD card into your computer
2. If the SD card has any files and folders on it, copy everything to a folder on your computer
3. Run SD Card Formatter Setup (the .exe file) in the downloaded .zip file with Administrator privileges, then install the program
4. Run SD Card Formatter from the Start Menu
5. Select your SD card’s drive letter for "Select card"

   Make sure you choose the correct drive letter, otherwise you might accidentally erase the wrong drive!

6. Ensure that "Quick Format" is selected
7. Click "Format"
8. Click "OK"
9. Wait for the format to finish
10. Click "OK"
11. Close SD Card Formatter
12. If the SD card had any files and folders on it before the format, copy everything back from your computer
    • If you are in the process of following the MSET9 fresh troubleshooting guide, skip this step, or else the error is likely to keep happening.

SD Card not formatting or has some other issue.

Refer to the SD Clean guide.