3DS:Alternate Exploits/Installing boot9strap (Stealth Luma3DS)

Required Reading

This method applies to devices that were purchased from certain sellers on Amazon or AliExpress, usually "Ancient Moon Game Store". These devices come with a specially modified version of Luma3DS to hide all configuration and features. During attempts to set up homebrew, this causes problems, usually when attempting to run nimdsphax. This guide explains how to replace it with a standard boot9strap install. If you were sent this guide in the Nintendo Homebrew Discord server with proper intent, do not follow any previous CFW installation method you were following (Skaterhax, SSLoth-Browser, etc.) and only remain on this guide.

What You Need

• The latest release of Luma3DS (the Luma3DS .zip file)
• The latest release of boot9strap (direct download)
• config.bin (direct download)
• Original 3DS/2DS consoles: This native.firm (direct download)
• NEW 3DS/2DS consoles: This native.firm (direct download)

On Windows, don't use WinRAR to extract files. It has a high chance of corrupting files, leading to confusing errors.

Instructions

Section I - Prep Work

1. Power off your device
2. Insert your SD card into your computer
3. Copy boot.firm and boot.3dsx from the Luma3DS .zip to the root of your SD card
   • The root of the SD card refers to the initial directory on your SD card where you can see the Nintendo 3DS folder, but are not inside of it
4. Create a folder named boot9strap on the root of your SD card
5. Copy boot9strap.firm and boot9strap.firm.sha from the boot9strap .zip to the /boot9strap/ folder on your SD card
6. Create a folder named luma on the root of your SD card, if it does not already exist
   • If this folder already exists and there is a file named config.bin inside it, delete this file
7. Copy native.firm to the /luma/ folder on your SD card
8. Copy the config.bin to the /luma/ folder on your SD card
9. Reinsert your SD card into your device

Section II - Installing boot9strap

1. Power on your device
2. If the exploit was successful, you will have booted into SafeB9SInstaller, then immediately have booted into the Luma3DS configuration menu
   • Luma3DS configuration menu are settings for the Luma3DS custom firmware. Many of these settings may be useful for customization or debugging
   • For the purpose of this guide, these settings will be left on default settings
   • If your device shuts down when you try to power it on, ensure that you have copied boot.firm from the Luma3DS .zip to the root of your SD card
   • If your device booted to the HOME menu without showing SafeB9SInstaller, proceed to Installing boot9strap (MSET9).
3. Press (Start) to save and reboot
   • If you get an error, just continue to the next section

At this point, your console will boot to Luma3DS by default. Luma3DS does not look any different from the normal HOME Menu. If your console has booted into the HOME Menu, it is running custom firmware. On the next page, you will install useful homebrew applications to complete your setup.

Section III - Removing files

1. Power off your device
2. Insert your SD card into your computer
3. Delete native.firm from the /luma/ folder on your SD card

---

Continue to Finalizing Setup