|
|
| (2 intermediate revisions by the same user not shown) |
| Line 1: |
Line 1: |
| This page is for resolving the "System Settings loading infinitely after reinserting the SD card" error when trying to [https://3ds.hacks.guide/installing-boot9strap-(mset9)#section-ii---mset9 install MSET9]. This page hashes out the troubleshooting steps located [https://3ds.hacks.guide/troubleshooting.html#installing-boot9strap-mset9 here].
| |
|
| |
|
| This will perform a fresh install for MSET9 to work properly.
| |
|
| |
|
| |
|
| |
|
| |
|
| |
| == Instructions ==
| |
|
| |
| Assuming your 3DS is stuck at the extra data screen with a spinning circle:
| |
|
| |
| # Force power off your console by holding the power button down for 15 seconds.
| |
| # Eject the SD from your console and insert into your PC.
| |
| # Load `mset9.bat` (if windows) or `mset9.py` (if linux) or mset.command (if mac).
| |
| # Choose model then press `3` to remove MSET9 and then press enter to close the script.
| |
| # Choose option below based on if you have a spare SD card or not.
| |
|
| |
|
| |
|
| |
| <tabber>
| |
|
| |
| |-|Spare SD Card=
| |
|
| |
| <span>
| |
|
| |
| # Eject the original SD card from your PC
| |
| # '''PUT YOUR ORIGINAL SD CARD AWAY'''
| |
| # Insert your spare SD card into your PC
| |
| # [[Formatting_an_SD_card|Format the spare SD card as FAT32]]
| |
| # Insert the formatted, blank SD card into your console
| |
| # Return to [https://3ds.hacks.guide/installing-boot9strap-(mset9)#section-i---prep-work Section I Step 1] of the MSET9 Guide.
| |
| # After Luma3DS installs and your console boots to the homescreen, power it off and switch to your original SD card for [https://3ds.hacks.guide/finalizing-setup.html Finalizing].
| |
|
| |
| </span>
| |
|
| |
| |-|No spare SD card=
| |
|
| |
| <span>
| |
|
| |
| # Backup your SD card to a folder to your PC (especially the Nintendo 3DS and DCIM folders)
| |
| # ''Double check that you properly backed up your data''
| |
| # Do not skip the previous step
| |
| # [[Formatting_an_SD_card|Format the SD card as FAT32]]
| |
| # Insert the formatted, blank SD card into your console
| |
| # Return to [https://3ds.hacks.guide/installing-boot9strap-(mset9)#section-i---prep-work Section I Step 1] of the MSET9 Guide.
| |
| # After Luma3DS installs and your console boots to the homescreen, power it off restore your backed up data to the SD card and continue on to [https://3ds.hacks.guide/finalizing-setup.html Finalizing].
| |
|
| |
| </span>
| |
|
| |
| </tabber>
| |
