No edit summary |
|||
Line 1: | Line 1: | ||
{{Page WIP|notes= | |||
*This page needs to actually do repartitioning properly, or else on certain SD cards that come with exFAT, the partition table won't be updated to reflect this. Maybe use fdisk for this? | |||
*GUI options for people who can use that such as GNOME Disks or GParted (which can be installed with most package managers). | |||
}} | |||
This is an add-on section for formatting an SD card to work with the 3DS. | This is an add-on section for formatting an SD card to work with the 3DS. | ||
Revision as of 05:15, 8 July 2022
This page is a work in progress. Notes:
|
This is an add-on section for formatting an SD card to work with the 3DS.
If the 3DS already recognizes the SD card, this guide is not required.
This page is for Linux users only. If you are not on Linux, check out the Windows or Mac pages.
Instructions
- Make sure your SD card is not inserted
- Launch the Linux Terminal
- Type
watch "lsblk"
- Insert your SD card into your PC
- Observe the output. It should match something like this:
NAME MAJ:MIN RM SIZE RO TYPE MOUNTPOINT mmcblk0 179:0 0 3,8G 0 disk └─mmcblk0p1 179:1 0 3,7G 0 part /run/media/user/FFFF-FFFF
- Take note of the device name. In our example above, it was
mmcblk0p1
- If
RO
is set to 1, make sure the lock switch is not slid down
- If
- Hit CTRL + C to exit the menu
- Type in the following for your SD card:
- 2GB or lower:
sudo mkfs.fat /dev/(device name from above) -s 64 -F 16
- This creates a single FAT16 partition with 32 KB cluster size on the SD card
- 4GB - 128GB:
sudo mkfs.fat /dev/(device name from above) -s 64 -F 32
- This creates a single FAT32 partition with 32 KB cluster size on the SD card
- 128GB or higher:
sudo mkfs.fat /dev/(device name from above) -s 128 -F 32
- This creates a single FAT32 partition with 64 KB cluster size on the SD card
- 2GB or lower: